CDLGeneral KnowledgePractice TestTest Strategy

CDL General Knowledge Practice Test: 150 Questions, the Rules That Matter

The key rules behind 150 CDL General Knowledge test questions: stopping distances, following distance, emergencies, weather and cargo, with explanations.

October 29, 2026 · Commercial Driver Prep team
CDL General Knowledge Practice Test: 150 Questions, the Rules That Matter

Long practice-test videos give you 150 questions in a row, and most people try to memorize them answer by answer. That’s the slow way. The real CDL General Knowledge test won’t use the same wording, and the answer letters won’t be in the same order. What stays the same is the rule behind each question, and every one of those rules comes from your state’s CDL Manual.

We grouped a full 150-question General Knowledge set into the rules it actually tests. If you learn these, you’ll know the answer however the question is worded.

The numbers you must know cold

Number questions are the easiest points on the test, but only if you’ve memorized the figures. They’re also the easiest to mix up under pressure.

RuleThe number
How far ahead to look12–15 seconds (about 1/4 mile at highway speed, about 1 block at low speed)
Dim high beams for oncoming trafficWithin 500 feet
Following distance (under 40 mph)1 second per 10 feet of vehicle length
Following distance (over 40 mph)Add 1 extra second
Wet road speed reductionAbout 1/3
Snow-packed road speed reductionHalf or more
Doubling your speedTakes 4 times the stopping distance
Reacting half a second slowerDoubles your chance of a crash
Inspect tires in hot weatherEvery 2 hours or 100 miles
Leaving the road in an emergencyAvoid braking until you’re below 20 mph

Tip: Here’s a typical following-distance question. You’re in a 40-foot vehicle at 35 mph, so the answer is 4 seconds. If the speed goes over 40 mph, the answer becomes 5. These questions are written to catch drivers who forget the extra second above 40 mph.

Total stopping distance = perception distance + reaction distance + braking distance. Perception distance is how far you travel from the moment your eyes see a hazard to the moment your brain recognizes it. Don’t mix it up with reaction distance, which is the time it takes your foot to move to the brake.

Alcohol, drugs and fatigue

The CDL Manual is strict here, and the test is too:

  • Only time sobers you up. Coffee and cold showers don’t work.
  • Alcohol affects judgment and self-control first, which is why it’s so dangerous behind the wheel.
  • Implied consent means that by driving, you’ve agreed to be tested for alcohol in your blood.
  • Over-the-counter cold medicine often causes drowsiness, so don’t take it before driving. When a doctor prescribes medication, ask whether it will affect your driving.
  • Sleep is the only cure for fatigue. A coffee break is not a substitute for a nap. Take short breaks before you get drowsy.
  • Sleep debt can only be paid off by sleeping.

Remember: On the test, hours of service means balancing your on-duty time with enough sleep to stay alert. For the federal limits in detail, see our Hours of Service cheat sheet.

Vehicle inspection

The main reason to inspect your vehicle is safety. “It’s the law” is true, but it’s not the best answer. Federal and state inspectors can inspect your truck or bus and put it out of service if it’s unsafe.

Points the test likes to ask about:

  • Brake shoes must not have oil, grease or brake fluid on them.
  • Cracked spring hangers and missing leaf springs are dangerous.
  • Check brake adjustment often, because brakes go out of adjustment with heavy use.
  • Valve clearance isn’t part of the engine compartment check, and fuel level isn’t a walk-around item.
  • Adjust mirrors before the trip, with the trailer straight.
  • In cold weather, give the exhaust system extra attention, because leaks can put carbon monoxide into the cab.
  • Never remove the radiator cap on a pressurized system until the engine has cooled.

For the complete walk-around in order, use our 11-point pre-trip inspection checklist.

Speed, space and seeing

  • Pick a speed that lets you stop within the distance you can see ahead, and at night, within the range of your headlights.
  • In heavy traffic moving at 35 mph in a 55 zone, the safest speed is 35 mph, the speed of traffic.
  • On grades, choose a safe speed based on your vehicle and cargo, within the posted limit.
  • Downshift before you enter a curve or start down a grade. Use a lower gear going down a hill than you used to climb it.
  • Empty trucks can take longer to stop than loaded ones, because they have less traction. This is a common trick question.
  • Scan back and forth, near and far. Don’t just stare straight ahead.
  • If an oncoming driver’s high beams are blinding you, look at the right side of the road.
  • Signal early and change lanes slowly. Keep signaling through a turn, because you need both hands on the wheel.
  • When someone tailgates you, increase your following distance. Don’t flash your brake lights.
  • Avoid backing whenever you can. When you have to back up, use a helper if possible.

Hazards and weather

SituationRight answer
HydroplaningRelease the accelerator
Glare iceStop driving as soon as you safely can
Heavy fogPark at a truck stop or rest area until it lifts
Very hot pavementTar bleeds and makes the surface slippery
Strong crosswindsWorst when exiting tunnels, and empty doubles are most affected
Driving through deep waterApply the brakes gently while driving through it
Work zonesSlow down further whenever workers are present
Hazard on the road aheadUse four-way flashers or brake lights to warn others

Low tire pressure makes hydroplaning more likely, and it can happen in shallow water. Overpasses and bridges freeze first.

Did you know? The CDL Manual names driving too fast for conditions as the cause of most serious skids. Speed is also the main cause of fatal crashes.

Emergencies and evasive action

These are among the most commonly missed questions, because the right answer often goes against instinct:

  1. Oncoming driver in your lane: steer to the right, not into the left shoulder.
  2. Tire blowout: stay off the brake until the vehicle has slowed down. Hold the wheel firmly.
  3. Front tire failure makes steering feel heavy and pulls the wheel. Rear tire failure can cause fishtailing, but dual rear tires usually prevent it.
  4. Steering around a hazard: don’t brake while you turn, and don’t turn more than you need to. Countersteering means turning back the other way once you’re past the obstacle.
  5. Hydraulic brake failure: pump the pedal to build pressure.
  6. Brakes fail on a downgrade: get off the road as soon as possible, using an escape ramp if there is one. Any driver who has lost braking power should use one.
  7. Emergency braking: brake so the vehicle stays in a straight line. If the wheels are skidding, you can’t steer.
  8. Front-wheel skid: the vehicle goes straight ahead no matter how you turn the wheel.
  9. Rear-wheel acceleration skid: stop accelerating.
  10. At a crash scene: protect the area first. Keep injured people warm, not cool.
  11. Stopped on a hill or curve: place the rear triangle as far back as you need to so drivers get adequate warning.

Brake fade comes from overheated brakes. The heavier and faster you are, the more heat the brakes have to absorb.

Cargo, weight and HazMat basics

  • The total weight of the power unit, trailer and cargo is the Gross Combination Weight.
  • Bridge formulas allow less weight on axles that are closer together.
  • Your vehicle’s weight changes its height, so don’t assume posted clearance signs are correct.
  • Blocking goes on the front, sides and back of the cargo, at the floor. Keep the load balanced.
  • Hanging meat and livestock are unstable loads that need extra care in curves.
  • Oversize loads need special transit permits.
  • Water is safe only on tire fires. Don’t use it on electrical or gasoline fires.
  • Placards go on all four sides of the vehicle. If a load requires placards and you don’t have the H endorsement, refuse it.

The HazMat material on the General Knowledge test only scratches the surface. If you’re going after the endorsement, read our HazMat endorsement guide.

How to study a 150-question bank

Going through 150 questions twice doesn’t help much if you’re just memorizing letters. Here’s a better approach:

  • After every miss, write down the rule in one line, not the answer letter.
  • Pay close attention to “which is NOT” questions. Read the stem twice.
  • Re-quiz only the topics you missed, then take a fresh timed mock test.
  • Book the real test once you’re scoring 90%+ consistently.

Our CDL mock test strategy guide shows how to get from 60% to 95%. For more practice, work through the 60-question General Knowledge set.

Start practicing with real explanations

Any website can give you a correct answer. What gets you through the real test is knowing why an answer is correct and which CDL Manual section it comes from. That’s how our apps are built.

The CDL Test app covers the CDL General Knowledge test and all endorsements, with an explanation for every question that ties back to the manual. It’s part of the Commercial Driver Prep suite: 1200+ questions across 3 focused apps, together with our HazMat and Air Brakes apps for when you add endorsements.

Try a free quiz now: start the CDL practice quizzes →

Frequently asked questions

How many questions are on the CDL General Knowledge test?
Most states use 50 multiple-choice questions, and you need 80% to pass, which means at least 40 correct. A few states vary the format a little, so check your state's CDL Manual or DMV website before test day.
Are the questions on CDL practice tests the same as the real exam?
They won't be word-for-word, but they cover the same rules. Every General Knowledge question traces back to a section of your state's CDL Manual, so if you learn the rule behind each practice question, a reworded version on the real test won't throw you.
What is the following distance rule on the CDL test?
Leave at least 1 second for every 10 feet of vehicle length at speeds below 40 mph. Above 40 mph, add 1 more second. So a 40-foot vehicle at 35 mph needs 4 seconds, and the same vehicle at 55 mph needs 5 seconds.
What is the hardest part of the CDL General Knowledge test?
Most applicants struggle with the numbers: stopping distances, following distance, how far to look ahead, when to dim headlights, and how much to slow down on wet or snowy roads. Questions that ask which answer is NOT true also catch a lot of people. Memorize the key figures and read every question stem twice.
Can I drive a truck hauling hazardous materials without a HazMat endorsement?
Only if the load doesn't require placards. If a load needs placards and you don't have the HazMat (H) endorsement on your CDL, you have to refuse the load. You can't haul it partway and hand it off to someone else.

Put what you've read into practice

Free practice quizzes for CDL, HazMat and Air Brakes — no signup.